全站仪使用方法（Use of the whole station）.docVIP

全站仪使用方法（Use of the whole station） The whole station is used. TXT Using the method, the whole station is used in the main building of the small middle and middle building Overview of the station: Instrument panel appearance and function description The buttons on the panel are as follows: Going into the coordinate measurement mode key, So were going to go into the distance measurement mode, ANG -- entering Angle measurement mode key, MENU - enter the main MENU to measure mode key, ESC - to interrupt ongoing operations, return to the previous menu, POWER -- key to POWER supply, -- the cursor moves the keys, The digital image - the cursor moves up and down, the screen keys, F1, F2, F3, F4 -- soft function keys, whose functions correspond to commands displayed on the corresponding display on the display screen, 1 - - 9 represents the numeric letter key, which corresponds to the input number corresponding to the letter below. The meaning of the symbol on the display: V -- vertical disk reading; HR - level reading (right direction counting); HL -- horizontal reading disk reading (left to count); HD -- horizontal distance; VD - the height difference between the instrument telescope and the prism; SD - oblique distance; * -- ranging; N -- north coordinates, x; E to the east, y; Z -- zenith directional coordinates, elevation H. Test site: the point where the instrument is aimed at the middle is the site. (figure B: site C) The rear view point: the instrument used to determine the north direction of the site is the rear view point. (figure B, given point A, when you aim at point A with the full station telescope, is to determine the direction in which the instrument is in the north.) Sample points: only know the coordinates on the drawing, and do not know the location of the site. The points that need to be determined by the coordinates corresponding to the coordinates are the lofting points. (figure B, point P1) The coordinate representation of the whole station corresponds