6-ISO12165压缩模,注射模,压铸模术语.docVIP

Tools for moulding — Components of compression and injection moulds and diecasting dies — Terms and symbols 成型模 压缩模、注射模和压铸模零件 术语和符号 【ISO 12165:2000 (Ed1)】 2.1 Plates: 1.带定位圈外伸座板 clamping plate, overhanging with centering recess 2.无定位圈外伸座板 clamping plate, overhanging without centering recess 3.带定位圈周边平齐座板 clamping plate, flush with centering recess 4.无定位圈周边平齐座板 clamping plate, flush without centering recess 5.定模型腔板 cavity plate, fixed half 6.动模型腔板 cavity plate, moving half .垫板 intermediate plate 8.推杆固定板 ejector retainer plate 9.推板 ejector base plate 10.垫块 riser Accessories: 11.推板联接杆 ejector rod 12.限位垫 seating washer .调整圈 distance disc15.圆截面压缩弹簧 compression spring, round cross section16.弹性柱塞 spring plunger 1.带肩定位导柱 locating guide pillar, shouldered 1.带肩导柱 guide pillar, shouldered 1.直导柱(斜销) guide pillar, straight (angle pin) .导柱 guide pillar 2.带头定位导套 locating guide bush, headed 2.带头导套 guide bush, headed 2.导管 guide sleeve 2.内六角止动螺钉 hexagon socket set screw 2.型芯 core pin 2.滚珠导套 ball guide bush 2.吊环螺栓 lifting eye bolt 2.沉头螺钉 countersunk socket head screw29.支承柱 support pillar 30.碟形弹簧 disc spring .圆形定位元件 locating element, round 3.定心套 centring sleeve 33.动模定位圈 locating ring, moving half .定模定位圈 locating ring, fixed half .内六角螺钉 hexagon socket head cap screw 3.圆柱销 dowel pin 2.3 Components for gating: 37.浇口套 sprue bush 38.拉料杆镶套 sprue puller insert 3.单探针加热喷嘴 heated nozzle, single probe .分流套（不加热） distributor bushing, unheated.过滤管 filter cartridge 4.直杆热流道板 hot runner manifold block, straight bar 4.气压喷嘴 pneumatic nozzle .气压针阀 pneumatic needle valve 4.隔热垫 spacer disc .鱼雷形分流梭 torpedo 4.熔料腔衬套 melt chamber bush Components for cooling/heating 51.连接卡箍 connection housing .带阀管接头 shut-off nipple, with valve.压力传感器 pressure transducer 5.加热圈 heater band 56.圆筒形加热器 cartridge heater, cylindrical .圆锥形加热器 cartridge heater, tapered 58.型腔压力传感器 cavity pressure transducer .管形加热器 tubular heater (列管式