平法施工图的看图要点(国外英文资料).docVIP

平法施工图的看图要点(国外英文资料) Flat picture point method of construction drawing 2008-04-06 00:48. Look at the points of working drawings generated by the Look at the contents of the structural design instructions; for example, remember the seismic grade of each component, the strength grade of the concrete, etc. See the main points: 1 according to the corresponding floor plan, proofread the axis, the axis number and the axis size; 2, according to the corresponding building floor plan room partition, wall column layout, check the beam layout is reasonable, beam axis positioning size is complete and correct. 3 carefully check the number of each beam, span, section size, reinforcement, stirrups, and relative elevation. First, the girder or sub beam is distinguished according to the support condition and span number of the beam, and the cross number is checked correctly; The same problem must be encrypted for the beams and joints And the spacing is not 100, but 5D The reinforcement of the connection area of longitudinal reinforcement is independent of seismic and aseismic 4, if the main beam, check additional lateral reinforcement are missing, cross section size, beam elevation, meet the secondary beam support requirements. 5 check the beam section size and beam relative elevation and building hole size, roof elevation, etc. there is no contradiction between node detail. Check the concentration of labeled upper beam reinforced with in situ reinforced mark long without contradiction; 6 check the focus marking upper beam reinforcement and reinforced in situ labeling usually has no contradiction; often ask some drawings are not labeled what some beam 8 check the stair platform beam and the platform plate whether there is no support This is a common design problem Stair platform beams and platform plates without bearings are a common design problem Because the stair beam and platform board are usually placed behind the wall In the construction of the subject requires personnel up and