广厦结构常用语(国外英文资料).docVIP

广厦结构常用语(国外英文资料) [frequently used words] Explain: Supplementary notes: The plate thickness not specified is 100mm The grade of concrete is C25 No marked plate top elevation is 2.910 The%%p0.000 elevation of this building is equivalent to the absolute elevation 12.340m The components shown in this drawing are all C25 grade concrete pouring For frames with KZ1~KZ20 reinforcement, see twentieth sheets For shear walls and concealed columns, see tenth sheets Column ZJ-1~ZJ-20 plane position. Twentieth For the KZ1~KZ20 position of the frame column, see twentieth Details of the frame joints and reinforcement are shown in twentieth sheets See tenth for specific notes See the general plan of this project The dimensions of the works are in millimeters, the elevation is relative elevation, and the units are meters Except for those marked, the beam reinforcement shall be%%1308@100/200 Double layer bidirectional Parapet practice see building plans Trench cover Perimeter arrangement Seam reinforcement Indoor ground Anchor entry column 40d Drain pipe D=50 Plate top elevation The foundation design of the building falls on the pebble bed Such as the buried depth of the foundation failed to reach the design bearing layer The building is designed according to fk=120kpa, and the groove is fulfilled after foundation pit excavation If the bearing capacity of the foundation does not meet the design requirements, the basic design shall be revised The main bars of some constructional columns are used as lightning protection and lead wires, and the construction should be coordinated with electrical engineering The foundation must be on the designed bearing layer, and the over excavation part shall be backfilled with graded sand and gravel Concrete mark: Foundation: C15 concrete wall and ground beam: C20 Indoor trench practices are using the 86J334 Atlas 20 thick 1:2.5 cement mortar (seepage 3% waterproof agent) 4 thick polyester tire modified asphalt felt C50 light steel keel 10 thick cement