机器的保养（国外英文资料）.docVIP

机器的保养（国外英文资料） The temperature of the environment is kept at room temperature (about 22 degrees Celsius), with a certain humidity and minimal dust. 2, maintain the machine regularly, reduce the effect of dust, ink, etc. On machine, Car sliding axis: daily to wipe, with a clean cloth or paper towel and alcohol, prohibited in any clock oil brush ink cartridges (black ink head of small box) weekly cleaning, remove the water wash, brush and ink dont lost and the correct place The grating bar is cleaned every week, and the daily watch, the q-tips, the distilled water or the alcohol are wiped, not too hard A daily inspection of the contact of ink and ink head to ensure that there is no ink stain, and that too much wine can dissolve microelectricity Wash ink cartridges (small box of ink cartridges) clean, remove water and rinse, not to lose and correct the ink. Be careful not to use oily ink, oil is easy to corrode ink system and block ink head. Original ink is your best choice. Do not mix ink. Unable to plug and wire line, otherwise it will cause damage to the main lever. 5, pay attention to the ink head nozzle dont wipe, can be used with ink not depilate cloth or good quality paper towels to absorb glue dry, otherwise may lead to blockages in the ink hole. The machine must be connected to the ground; The electrostatic problem should not be ignored when the air is dry, and when using certain antigels and laminators, the static charge (especially when the paper is working very fast); Electrostatic charge can lead to the machine and the ink head of security is damaged, will take the earth wire static interpretation of the power supply, so in the charged operation when the ink head, ensure that the hands have discharge, (contact grounding metal body or wear in addition to electrostatic bracelets, otherwise easy to cause the ink head damage of individual ink. Ground requirements and methods: Grounding wire shall be made of single ply copper wire or coiled wire with stronger m