网吧驱动常见故障排除50例(无盘有盘显卡系统)（国外英文资料）.docVIP

网吧驱动常见故障排除50例(无盘有盘显卡系统)（国外英文资料） Problem: the sea spider in our net cafe route has 3 network card, 1 board load (SIS), a piece of RTL8139, an Intel 82559 100 M In the hardware information, you can see that three network CARDS are identified, but the access Settings menu for the route has only one configuration for the wan interface Like Intels ubiquitous network card, theres a built-in driver for the route, and theres no problem with the driver. Whats wrong with the network card hardware Reference methods: 1. Block off EEPROM * if the onboard Intel network card, the BIOS turns off the EEPROM function * if it is separate, it should be fine to start the EEPROM on the network card The function of EEPROM chip is mainly used for the remote network to wake or switch machine, and do not use the same single machine When loading the network card driver, the specified parameter ignores the EEPROM error Enter the system Settings - network card driver module and enter the following line: E100 eeprom_bad_csum_allow = 1 Intel has a similar way of doing it, but when loading the module it is: E1000 eeprom_bad_csum_allow = 1 Problem: when youre doing sharp, you encounter NVIDIA nforce 6100-430. The system can upload success, but it launches to the scrollbar From the beginning, the failure occurred and then changed the machine and the system but the phenomenon is the same, so it is suspected that the card driver has a problem What drives the untray. Reference methods: Ann USES a computer with a hard drive to install the system, but do not install the network card driver. (if this is the Internet card driver, it is not when it is launched without a disk In the case of a scrollbar machine, reboot), Install the sharp client side, restart the computer, then install the network card driver, the nForce motherboard proposal USES 67.62 version of the network card driver Question: ask your expert, which version of LINUX has changed, and I download LINUX on INTELs website RAID drivers, he offer