落地足手架(国外英文资料).docVIP

落地脚手架(国外英文资料) Loosen the fastener, the flat bar piece and so on should be taken down, not loose on the shelf. The removal of long rods should be done in parallel with both of them in order to avoid the mishap of a single task. The removal of the rod should be carried to the ground, not to be thrown down. Special people should be set up for protection. The mud-working class must be arranged with the removal process in time to make up for the work of the outer wall and the filling hole. Safety management of scaffolds The standard bricks piled on each floor of the bridge shall not be more than a single row of three floors; The mortar and the container must weigh no more than 1.5kn; The construction equipment list shall not be greater than 1KN; The weight of the components used for handling and mounting on the frame shall not be greater than 2.5 KN. The materials on the bridge shall be stacked up and stable, not to affect the operation of the construction and the personnel. 3, homework personnel in the rack should be the maximum height assignment for normal operation for degrees, ban on the plane board padded implements or single piece of scaffolding in order to increase operation level. In the work, the basic structural component of the scaffold, the whole piece, the fasteners and the wall are forbidden. To ensure that the operation requires a temporary demolition, it must be approved by the competent person and the corresponding remedy shall be taken, and the recovery shall be given immediately upon completion of the operation. 6 Liaoning zhongda construction engineering co., LTD When working on a shelf, workers should pay attention to the safety of themselves and the safety of others, avoiding collisions, missteps and falling objects. Rack frolicking and sitting on a rail uneasy QuanChu chief attractions in rest, 6, up and down the scaffold must set security access (ladder), it is forbidden to climb the scaffold. The workers should check the safety issues before the