艇筏把持任务法度模范(国外英文资料).docVIP

艇筏操纵工作程序(国外英文资料) The operation of the ships life-saving equipment The operating procedure of the lifeboat Lifting and fixing of the 1.1 lifeboat (gravity boat frame) 1) the captain of the boat was standing at the side of the boat, taking off the hood. Then two people embarkation, loose the lifeline, plug on the bottom of the boat, check whether the steady painter is loose, take fore and aft, and send the check rope, pull the safety pin, relief safety hook, check whether the short cable is fastened, unload beam. 2) after hearing the captains breath, the deputy captain raised the mechanism of the boat and lowered the boat to the deck of the embarkation boat. The crew boarded the boat. 3) after the embarkation, loose end line and short line, will continue down to the water boat, maintain the mechanical boat fall to a certain extent, craft workers pull up linkage decoupling control loop, the boat. 4) the boat people use the rope ladder or the lifeboat. 5) put on the tiller, release the head and stern line, and then move quickly out of the ship about a quarter of the time. 6) the motor boat should start the boat before it lands in the water, so that the boat can move away from it. Boat and fixed 1) before the boat, the crew will be left with two skilled hooks on the boat, and the rest will board the ship from the side of the ship, or the rope ladder. 2) the boat is adjusted by large ships to make the boat under the boat block, and try to make it as easy as possible to hook and not allow the rope to be too loose. After the hook is hung, the boat should be hoisted out of the water immediately. When rolling, the ship should be quickly pegged from the other side to the floating point, then hoisted the boat out of the water as soon as possible. 4) boat crane to suspend the boat deck, mount short line, in the beginning and the end of the boat and cable tray is good, open the boat bottom plug put clean water, will check the swing block unit into the boat, the last two hooks cr