手机触摸屏进水的处理(国外英文资料).docVIP

手机触摸屏进水的处理(国外英文资料) Touch screen water on the phone A few days ago, the friends jinpeng mobile phone accidentally went into the water. He knew that I liked to play with the little things, so I took a look and said, let me learn to do it. I repeatedly said that it was very cheap and difficult to play with. Never mind, at most I dont need a touch screen. He left this sentence and left... I scratched my head and shook my head helplessly. Mobile phone screen fill out of my expectation, the entire screen in the middle of the water is all about two-thirds, boot up, part of the key work, touch screen is no good. With so much water in the water, it seems impossible to simply take the whole machine to dry. Step 1: remove the screen Jin peng S7559 USES a 2.6 screen, the touch of a touch screen is a resistance type. (most mobile touch screens are now made of resistive touchscreens). Carefully cracked open the phone, remove the screen (the structure of the touch screen is: a full of tiny transparent plastic sheet of conductive wire + a is full of tiny glass of conductive wire. Through the size of pressure to change the electrical resistance of the touch screen between the poles, to achieve the goal of changing input command.) The touch screen is glued to the display board. There are two lines on the display, the display board and the touchscreen. The line is plugged into a plugged socket, which can be easily removed by carefully prying up the pressure plate on the socket. After take off screen, look carefully touch screen, the water to see if you can take online some posts, can use hot air to blow dry hair dryer. When use hair dryer, dare not to use too hot wind, also dare not too close to the touch screen, are all afraid of, because temperature is too high to touch screen deformation (because the touch screen is plastic) on one side the touch screen is completely discarded! Its been around for more than 20 minutes and the touch screen is already hot, but theres not much water