JGJ7391(国外英文资料).docVIP

JGJ7391(国外英文资料) Before construction of plastic floor, carpet, hard fiber board, etc., before the construction of the surface layer and the power line, and after the test pressure of the pipe equipment. The final coating of the floor of the wood floor, should be completed after the completion of the pasting project: 5, the pasting project shall be completed after the finishing of the coating and painting of the ceiling, wall, doors and Windows and construction equipment. Article 1.12 the environmental temperature of construction of decoration projects inside and outside the room shall meet the following requirements: A brush, pulp, finishes, and ornamental design engineering and senior plaster, solvent mixed color coating engineering should not be less than 5 ℃ : Second, the intermediate and ordinary plaster, solvent mixed color coating engineering, as well as glass engineering should be above 0 ℃ : Three, pasting project should not be below 10 ℃ : When using adhesives, the temperature construction required by the adhesive product description is required: Five, besmear brushs varnish should not be less than 8 ℃, the temperature of the latex paint should be in accordance with the requirements of the product description construction: Six, besmear outside lime mortar shall not be less than 3 ℃. Note: the environmental temperature is the lowest temperature in the construction site. Indoor temperature should be measured near the outer wall of the outer wall by 500mm. Article 1.13 decorative projects shall be protected by finished products, water for construction and test of piping equipment, and no damage to decoration projects. Article 1.14 the requirements for the construction safety technology, labor protection, fire prevention and anti-poisoning of decoration projects shall be carried out in accordance with the relevant provisions of the state. The material should be piled up with safety fire protection. Chapter ii the project of plaster Section 1 general provisions