Fx-5800p随便率性曲线中边桩,平曲+竖曲+地道超欠挖法度模范榜样(国外英文资料).docVIP

Fx-5800p任意曲线中边桩,平曲+竖曲+隧道超欠挖程序(国外英文资料) The G - 90 - T: Abs ((Y - V) cosT - (X - U) sin (T)) - W: 0 - Z: Lbl 0: Prog SUB1 : T + QEW (C + WD) - L: (J - Y) cosL - (I - X) sinL - Z: ifAbsZ 1 e - 6: thenGoto1: ElssW + Z?? - W: Goto 0: IfEnd Lbl 1:0 to Z: Prog SUB1 : (j-y) to sign the sine of f to Z The flat curve database (QYS) does not run If S starting point or pile number: Then start X coordinate to U: starting point Y - V: zero - O: the starting point of azimuth - G: the length of the line element - H: starting point line element radius - P: line element and end radius R: (turn right turn left - 1 1 0) straight - Q: Goto A: Ifend ......................................................................................................................................................... Lb1 A: Return The vertical curve database (SQX) does not run (changing slope point elevation) - [1] : Z (changing slope pile number) - B: (radius) - R: (tangent length) - T: - the longitudinal slope after () - J: (first grade) - I: K: B - K - C: 1 - U: I J = 1 - U If K T then 0 - A: B - I - P: Goto 1: IfEnd: If K then 1 B - A: I - P: Goto 1: IfEnd: If K 1 - A: B + T then J - P: Goto 1: IfEnd: If K B then 0 - A: J - P: Goto 1: IfEnd LbI 1: Z [1] - CP + AU (t-abs (C)) 2 sign on R to H: Return This program is easy to use N = 1 to enter the path coordinate is equal to the value of the number Z = offset So N equals 2 is going to go into the path coordinates and the inverse of that is XY (arbitrary point coordinates) N = 3 is going into the tunnel coordinate and the tunnel is going to be the same thing as the path of the tunnel and the SZ is going to be the XY and the azimuth and the height N = 4 goes into the tunnel and calculates the pile number and the station, XY, and the z fh N = 5 enter the tunnel three rounds test input FZ to calculate the undredging (1) to make a distinction between the forward direction of the middle line of the road (i.e. the direction of th