剪力墙模板工程技巧交底(国外英文资料).docVIP

剪力墙模板工程技术交底(国外英文资料) Shear wall template technical disclosure Qujiang lanting 7 # building Technical background of shear wall template engineering First, preparation for construction (1) working conditions The template is numbered according to the wall, and it is applied to the molds, the oil oil: the diesel = 5:5, the specification is piled up. 2, axis play floor, wall body lines, Windows and doors hole position lines, pop-up axis partial floor 500 mm module and auxiliary line, clean and clear the wall body area of sundry, all lines have preview. 3, embedded column wall, the wall, even the beam reinforcement assembling finished, hydropower embedded box, box, embedded parts, and do a good job in inspection, reinforced protective layer and steel frame column fixture knot spacing, number should meet the design requirements, horizontal, vertical ladder tendons installed, reinforcement measures have reliable positioning. 4, doors and Windows and other reserved templates have been installed in place correctly, and have reliable connection with the wall steel. The base of the wall of the wall 10cm should be covered with flat press and a 20cm thick foam strip at the root, in case of the slurry under the template, and note that the sponge should not be inserted into the wall. Before the template is installed, the construction seam between the wall and the roof should be finished, and the wall and the wall between the wall and the wall are finished, and have been checked. 7, the shaft of the elevator shaft is pre-installed in front of the floor, and four 250 x 200mm reserved holes are set aside to support the four steel legs of the working platform. (2) material requirements Wall form template: the basement USES small steel model to assemble. More than 0.000 or more adopt the large steel template. The thickness of steel plate is not less than 6mm, and the large templates are connected by means of the enterprise. The matching type of steel Angle mold, the large mold is connec