水泥厂 图纸编码说明.docVIP

LIST OF ENGINEERING STANDARDS 技术标准清单 W01 CODIFICATION OF EQUIPMENTW01设备编码 W02 CODIFICATION OF DRAWINGSW02 图纸编码 W03 PROCEDURE FOR ISSUING FLOW SHEETSW03 流程表发布程序 W04 PROCEDURE FOR ISSUING FLOW CHARTSW04 流程图发布程序 W05 PROCEDURE FOR ESTABLISHING LAYOUTSW05 布局确定程序 0 27/02/01 New version adapted to Lafarge Codification version 2 根据拉法基编码版本2修改的新版本 NM/RD/CM/MM ADM LC Rev. 修订 Date 日期 SCOPE OF REVISION 修订范围 ISSUED 签发 CHECKED 检查 APPROVED 批准 LAFARGE CENTRE TECHNIQUE INTER-UNITES L’Isle d’Abeau - Parc de Chesnes - BP.70 F-38291 St QUENTIN FALLAVIER Cedex Phone?: 33 (0) 4 74 82 18 15 / Fax?: 33 (0) 4 74 94 18 97 E-mail?: stephanie.bret@ Standard Technical Documentation VOLUME 1 Codification 标准技术资料第I卷编码 Reproduction usage strictly forbidden without explicit agreement (Law 11th March 1957) 未经明确同意严禁复制和使用（1957年3月11日法律） CONTENT 目录 1. CODING FOR DRAWINGS 3 2. 图纸代码实例 3 3. 编号 7 CODING FOR DRAWINGS图纸编码 Please see below the RECOMMENDED CODING FOR DRAWINGS for a plant or certain area of a plant (be it a process stage, line, sub-process stage , shop, or machine, etc.). 工厂或工厂的某些区域（可以是工艺阶段、生产线、子工艺阶段、车间、或机器等等)图纸推荐编码请参见下文。 The drawing number will take the following form: 图纸编号将采取以下格式： The drafting office shall use the Technical Center or Business Units Technical Management abbreviation (such as CTI, CTS, etc.) as plant codes when coding, Standard drawings, Reference drawings, etc. 给标准图纸、参考图纸等编码时，绘图室应使用技术中心或事业部技术管理缩写（例如CTI、CTS等等）作为装置代码。 DRAWING CODE EXAMPLE图纸代码举例 Code A 代码A Geographical Map - Topographic Map : 地图－地形图： Scale between 1/5000 to 1/25000. 比例在1/5000～1/25000之间。 Give the location of the project from a city, roads, stream and body of water and the geographical position. 从城市、道路、河流和水体以及地理位置给出工程地点。 Required for construction permit. 施工许可需要。 Cadastral Drawing : 地籍图： This drawing identifies the parcels, gives their size, shows official division line, official identification number, monuments and north point. 该图纸标识小地块，提供其大小，显示官方分