电焊工的安全技术操作规程（三）.docVIP

电焊工的安全技术操作规程（三） 电焊工的安全技术操作规程（三）提要：严禁在带压力的容器或管道上施焊，焊接带电的设备必须先切断电源 电焊工的安全技术操作规程（三） 1、电焊机外壳必须接地良好，其电源的装拆应由电工进行。 2、电焊机要设单独的开关，开关应放在防雨的闸箱内，拉合时应戴手套侧向地点工作。 3、焊钳与把线必须绝缘良好，连接牢固，更换焊条应戴手套，在潮湿的地点工作，应站在绝缘胶板或木板上。 4、严禁在带压力的容器或管道上施焊，焊接带电的设备必须先切断电源。焊接储存过易燃、易燃有毒物品的容器或管道，必须清除干净，并将所有空口打开。 5、把线、地线，禁止与钢丝绳接触，更不得使用钢丝接触，更不得使用钢丝绳或机电设备代替零线，所有地线接头，必须连接牢固。 6、更换场地移动把线时，应切娄电源，不得手持把线抓梯登高。 7、清除焊渣，采用电弧气刨清理时，应戴防护眼镜或面罩，防止铁渣飞溅伤人。 8、雷雨时，应停止露天焊接工作。施焊现场周围，应清除易燃爆物品，或进行覆盖、隔离。 9、必须在易然、易爆气体或液体扩散区施焊时，应经有关部门检查许可后，方可施焊。 10、工作结束后，应切断电焊机电源，并检查操作地点确认无起火危险后，方可离开。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family moral education network, to achieve full