电焊工的程安全技术交底范例.docVIP

电焊工的程安全技术交底范例 电焊工的程安全技术交底范例提要：电气焊的弧火花点必须与氧气瓶.电石桶.乙焕瓶.木料油类等危险物品的距离不少于10米，与易爆物品的距离不少于20米 自 电焊工的程安全技术交底范例 1.进入现场必须遵守安全生产六大纪律。 2.电焊、气割严格遵守”十不烧”规程操作。 3.操作前应检查所有的工具.电焊机.电源开关及线路是否良好，金属外壳应有安全可靠接地，进出线应有完整的防护罩，进出线端应有铜接头烧牢 4.每台电焊机应有专用的电源控制开关，开关的保险丝容量，应为该机的倍，严禁用其它金属丝代替保险丝，完工后切断电源。 5.电气焊的弧火花点必须与氧气瓶.电石桶.乙焕瓶.木料油类等危险物品的距离不少于10米，与易爆物品的距离不少于20米。 6.乙焕瓶、氧气瓶均设有安全回火防止器，橡皮管连接处须用扎头固定。 7.氧气瓶严防沾染油脂，有油脂衣服手套等，禁止与氧气瓶.减压阀氧气软管接触。 8.清除焊渣时面部不应正对焊纹，防止焊渣贱入眼内。 9.经常检查氧气瓶与磅头处的螺纹是否滑牙，橡皮管是否漏气.焊枪嘴和枪身有无阻塞现象。 10.注意安全用电，电线不准乱拖乱拉，电源线均应架空扎牢。 11.焊割点周围和下方应采取放火措施，并应指定专人放火监护。 12.补充交底内容：... 交底人： 年 月 日 自 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The