电焊工程安全技术交底范例.docVIP

电焊工程安全技术交底范例 电焊工程安全技术交底范例提要：焊接电缆应使用多股细铜线无接头电缆，与电焊机接线拉用线鼻子连接压实，防止随意缠绕造成的拉动与接触不良，过热、火花现象。接线接上方应设置防护罩 更多资料 电焊工程安全技术交底范例 1、应由经培训考核持有焊工上岗证的焊工操作，并按规定穿戴绝缘防护用品。 2、使用合格的电焊钳，严禁使用自制简易焊钳。 3、电气线路架设及焊机保护接地或保护接零装置符合施工临时用电规范要求，接地电阻不得大于4欧姆。 4、焊接电缆应使用多股细铜线无接头电缆，与电焊机接线拉用线鼻子连接压实，防止随意缠绕造成的拉动与接触不良，过热、火花现象。接线接上方应设置防护罩。 5、焊接电缆长度一般不超过20-30m。焊接电缆通过通道时，必须采取单独如护套、穿套等保护措施。 6、严禁使用脚手架、金属栏杆、轨道及其他金属物搭接代替导线使用。 7、凡在有接地或接零线的工件上进行电焊的，应将焊件上的接地线暂时拆除，焊完后再恢复。 8、在焊接与大地紧密和连接的工件上进行电焊时，如果焊体本身接地电阻小于4欧姆，则应将电焊机二次线圈端的接地线暂时拆除，焊接完后再恢复。 9、进行电焊作业前，应检查作业环境，消除危险因素和设置监护人员；当与其他人员和有关设施过近时，应采用屏护和安全问题等措施，保证作业安全，当高处焊接作业时，必须挂好安全带。 10、进行下列操作前应切断电源后进行： 1)改变焊机接头时；2)更换焊件需要改接二次回路时；3)转移工作地点时；4)焊机需检修时；5)暂停工作或下班时。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral