ml605_BIST_pdf_xtp056_12.1.pdfVIP

? Copyright 2010 Xilinx ML605 Built-In Self Test Flash Application May 2010 XTP056 Overview ? Xilinx ML605 Board ? Software Requirements ? ML605 Setup ? ML605 BIST (Built-In Self Test) ? Run ML605 BIST Ready for Download Files ? Compile ML605 BIST Design ? Generate ML605 BIST Design CompactFlash ? References Note: This presentation applies to the ML605 ML605 BIST Design Description ? Description – The Built-In System Test (BIST) application uses an EDK MicroBlaze system to verify board functionality. A UART based terminal program interface offers users a menu of tests to run. ? Reference Design IP – EDK IP: MicroBlaze, plb_v46, lmb_v10, mdm, lmb_bram_if_cntlr, bram_block, xps_bram_if_cntlr, xps_uart16550, xps_gpio, clock_generator, mpmc, proc_sys_reset, xps_intc, xps_timer, xps_sysmon_adc, xps_iic, xps_mch_emc, xps_sysace, util_io_mux, util_bus_split, util_vector_logic, xps_ll_temac, xps_tft, xps_epc ? Embedded System Tools Reference Guide (UG111) ? /ise/embedded/edk_ip.htm ? Reference Design Source – rdf0017.zip Note: Presentation applies to the ML605 Xilinx ML605 Board Note: Presentation applies to the ML605 ISE Software Requirements ? Xilinx ISE 12.1 software Note: Presentation applies to the ML605 EDK Software Requirement ? Xilinx EDK 12.1 software Note: Presentation applies to the ML605 Hardware Setup ? Set S2 to 011010 (1 = on, Position 6 → Position 1) ? Set S1 to 1000 (Position 4 → Position 1) – This enables JTAG configuration from the Compact Flash Note: Presentation applies to the ML605 ML605 Setup ? Power on the ML605 board for UART Drivers Installation ? Connect a USB Type-A to Mini-B cable to the USB UART connector on the ML605 board – Connect this cable to your PC Note: Presentation applies to the ML605 ML605 Setup ? Install USB UART Drivers – /Support Documents/Software/ CP210x_VCP_Win2K_XP_S2K3.zip Note: Presentation applies to the ML605 ML605 Setup ? Right-click on My Computer and select Properties – Select the Hardware tab – Click on De