TFT使用注意事项案例.ppt

This document is prepared to make an offer the guidelines for using *** LCD module safely and properly.  LCD module is composed of variable sensitive parts, so may easily damaged due to carelessness.  Please comply with the following precautions when shipping, unpacking, assembling or storing it. ;1) when LCD module falls from a high place or receives a strong shock, the glass may be broken.  Please minimize mechanical shocks to the goods when shipping, transporting and unloading LCD module.;5) Be careful sharp edge of box that may cause injuring fingers or skin.  Pick the pouch only, when taking out LCD module from a shipping package.;1) * Never disassemble and/or re-assemble the LCD module under any circumstances. Sensitive parts inside LCD module may be damaged and it may not be operated.  *** does not warrant the LCD module, if customer disassemble and/or re-assemble it.; (4) Do not touch the electrode area of PCB and electrical parts like LSI, capacitor, connector, etc. (5) The grounding should be done through a resister of 1M ohms in order to prevent spark of ESD. (6) When remove protection film from LCD panel, peel off the film slowly (more than three seconds) from the edge of the panel to minimize ESD.;5) The following precautions and instructions should be taken when assembling the LCD module.;1) It is recommended to handle the LCD module with soft gloves or finger stalls in order to keep clean appearance of LCD module.;8) Do not exceed the absolute maximum rating values under the worst probable conditions caused by the supply voltage variation, input voltage variation, variation in parts’ constants, environmental temperature, etc., otherwise LCD module may be damaged. ;4) It is recommended that suitable protection circuit should be applied for each system design.;1) * Please scrap the product according to the relevant