天行者2014 Skywalker 1900 安装说明书.docxVIP

Sky-Walker Pro Installation ManualThank you for purchasing the Sky-Walker Pro plane.The Sky-Walker Pro is designed for First-Person-Vision (FPV) application specifically.Due to the high wing and push prop design,the on-board camera could have a perfect view without being blocked.The large fuselage compartment design provides conveniency to contain almost any hobby FPV equipment.Other than that,the Sky-Walker Pro is also suitable for the beginners to leam flying as a high stable trainer plane.Before you start the installation,please read this manual carefully to have an overall idea of what to do.In the same time,please check all parts before you begin.If you find any missing or defective parts,please contact your local dealer.1,Required for Installation and Operation:Required RC Equipments:The below listed RC gears are not included.They may need to be purchased separately.For details,please check with your local hobby stop.Minimum 4-6 channel radio control systemMinimum 2 pieces of8- 9g micro servos or similar.4 servos are needed for full control of aileron,elevator and rudder2 pieces of 25~30cm servo extension cables for aileron servosAXI 2820KV920-1100 out-runner brushless motor or equivalent45-60A or above brushless ESC with 25~30cm length of the power input wireAPC9060E propeller or equivalent5000mAh 4S lithium-polymer battery pack or similarYou may need the following for FPV application:DC powered CameraPan/tilt camera mount with servos6 or more channel radio control system,instead of 3~4 channels for basic flyingWireless transmitter and receiver for on-board video transmissionOn-Screen-Display(OSD)system1000mAh 3S lithium-polymer battery pack or similar for the camera(refer to the manual of the camera system)3A490-1hgfrewqRequired Tools and Material for Installation:Phillips screwdriverallen keySharp hobby knifeHobby scissorsNeedle nose pliersWire cuttersAwlMarjer penFoam double-sided tapeFibre tapePaper tapeCable tightMalefemale Velcro tapeHot glue and hot