honeywellTraining_Prowatchlevel必威体育精装版门禁说课.ppt

* Default Connections for reader 0 * Default connections for reader 1 * 2 Reader Board Aux Inputs and outputs They can be used for anything and thier open, closed, or supervised state is selected in software. * 2 Reader RS485 Port In the enclosure this will daisy chain to the IC. In the field this will wire to the IC or to the next IO board. * 2 Reader Tamper and Power Fail Inputs * 2 Reader DIP Switches Address 32 is the same as 0 Baud rate should be 38,400 * 2 Reader Jumpers Selectable 5 or 12 volts for each reader and EOL terminator for the 485 bus. Remember…Only the last IO board on a bus is terminated. Pull the jumper off if this is not the last IO board. * 16 Input IO Board * 16 Inputs Can be used to monitor the status of anything with a dry contact connection. Each circuit can be set to Open circuit, Closed circuit, or supervised individually. * Aux outputs Both relays are single pole, 2amp. * Input Board RS485 Connections Wires back to the IC or to the next IO board. * Power fail and Tamper Inputs. You cannot change the way they report. * 16 Input DIP Switches This boards address (0-31) and 38400 baud rate. * 16 Relay Output Module * 16 Outputs 16 individual 2amp relays. All are single pole relays. All options are individually set for each relay. * RS 485 connections Wire to the IC or to the next IO Board * Power Fail and Tamper inputs * 16 Relay Output Board DIP Switches * Computer Name - Rt Clk “My Computer” / Properties / “Network Identification” Tab If setting up network then everyone changes the name to be unique with no spaces or dashes. Clk “Properties” to change the name. Workgroup or Domain : Rt Clk “My Computer” / Properties / “Network Identification” Tab If setting up a network, everyone should be in the same workgroup. Clk “Properties” to change Workgroup or Domain. TCP/IP Address: In the TCP/IP protocol, everyone must have a unique address. Part of the address is the workgroup you are in and part of it is the actual computers address