机舱设备系泊试验.docVIP

（A）泵浦系泊试验? ? for pumps1、管路（设备）安装检查? ???To check the piping（equipment）installation.2、起动试验? ?? ?Starting Test.3、电流（电阻）测量? ???To measure the electrical current（electrical resistance）.4、运转（真空）试验? ? Operation (Vacuum) test.5、自动运转（起、停）试验? ?Automatic change-over (start / stop) test.6、报警试验? ? Alarm test.（B）、锅炉系泊试验??for boiler1、相关系统检查? ? To check the relative systems.2、给水（燃油）泵运装试验??Running test for water feed（fuel oil）pump.3、锅炉及附件安装检查? ? To check the installation of boiler and its accessories.4、电气系统安装检查? ?? ? To check the installation of electrical systems.5、锅炉自动给水? ?Automatically feed water for boiler.6、自动转换（给水）试验? ?Automatic change-over (feed water) test.7、集控室水位遥测? ?The remote measurement of water level in ECR.8、锅炉点火燃烧运行? ? Ignition and combustion test for boiler.9、燃烧器自动切断? ? Automatic cut-off for burner.10、锅炉自动燃烧控制? ? Automatic combustion control for boiler.11、安全阀试验? ? Safety valve test.12、蓄压试验? ? Pressure accumulation test.13、应急停炉试验??Emergency stop test for boiler.14、锅炉蒸发量测定? ?To measure the steam production (evaporation) of the boiler.15、手动调节过量蒸汽阀? ?Hand-adjusting excessive steam valve.16、给水（燃油）流量??Feed water（F.O.） flowmeter.17、蒸发量? ?steam production / evaporation.18、记录其它数据? ?To record the other data.19、燃油器断开? ?To cut-off the burner.20、高（低）火燃烧??high (low) combustion.21、燃烧器起动燃烧? ?The burner has started to fire.22、锅炉蒸汽压力高（低）报警? ?Boiler high (low) steam pressure alarm.23、燃烧温度高（低）报警? ? High (low) combustion temperature alarm.24、给水盐度高报警??Feed water high salinity alarm.25、燃烧器回油管高压报警? ?The burner return oil pipe high pressure alarm.26、循环油管低压报警? ? Circulating oil pipe low pressure alarm. （C）、废气锅炉系泊试验??Mooring test for exhaust gas boiler1、相关系统确认? ? To confirm the relative systems.2、锅炉报警点试验? ? Boiler alarm point test.3、高水位报警? ???High water level alarm.4、备用给水泵启动报警? ? Standby water feed pump starting alarm.5、给水泵开（关）? ?To start (stop) the water feed pump.6、液位遥测? ? Remote level measurement.（D）、主空压机系统试验? ? Mooring test for main air compres