heating storage Air to Air heating recovery Machine.pptVIP

Heating or pressure compensation—pre-heating improve inlet temperature Heating storage sys for multi-tepm Air to Air heating recovery picture Air to Air heating recovery picture high efficient Air to Air heating recovery curveout let T 60 80 Degree C Test result Conclusion Promise With the help of Air to Air heating recovery SyS: We can reduce your heating cost 40-60% Replace diesel fuel ,running cost is only 25-30% of before; Replace LPG or LNG, cost will be 45-60% of before; Replace directly electric heating : for the day time shift8:00-22:00,cost will be 25-30%, for the 24 Hrs running shifts, cost will be 30-35% of before; Method of selecting of product Our Heating out put Must bigger litter bit than customer consumption Normally 10-20% is. That is mean 1.1-1.2 times bigger. Some function of our product Pre-Heating can divided 3 period Heating release can be 6 period Priority Temp out let or in let （water：0~95 ℃，oil：0~300 ℃ ±1 ℃ Safty Note Sys must connected to open system to air; No pressure in the pip, only cycle pump pressure. Product must connect to the Ground. Must connect to expansion tank. Transformer only can working on 85-90% of full rating plate. Oil sys in the Temp rise between 95~105℃,must pause, till no water inside, then to 230-250 pause again, till hydrocarbon vapor released, After that we can rise Temp to the setting T. Installation site request Need drainage oil water storage sys to prevent leaking Heating storage module are very heavy, need special base to support machine—9T on 1.2x2.4m Multi-modules must installed on ground or basement. Because we can unassembled to the parts. The entry door of the site can be very small or narrow. 1.0x2.0 minimum Front of machine need 2.0m, back side need 1.0 maintenance space, and two side need 1.0 meter walking space. On the top need 2.0 meters to install wire. Thanks very much 谢谢大家！ Maojing Why we need off peak power storage Electricity can not be stored middle night Human need