耐磨抗渗透乙烯酯树脂底层涂料吸收塔用.docVIP

Intended Uses 用途 专门设计用于FGD系统吸收塔内壁防腐涂装打底。也适用于一些与其他防腐性化学接触部位，关于适用介质种类请像本公司咨询。 Specially suited for painting the inner surface of FGD system absorption tower as a anti-corrosive primer, it is suited for anti-corrosive protecting the area which is close to chemicals too, about the detals, please consult to us. Product Information产品简介 以昭和公司的专用乙烯酯树脂为成膜基料，少量活性稀释剂，助剂等，施工时按照一定比例加入乙（固化剂），丙（促进剂）组份、混合均匀。 极佳的底材附着力性： 柔韧性、耐温变和抗疲劳特性；抗化学物质，耐常规化学品腐蚀。 This paint contains Special phenolic-modified vinyl ester from shouwa company, activity thinner and saaistants etc. Before application, please add component Band C into component A stir it thoroughly till to homogenous. Excellent adhesion to substrate Excellent fleibility, temperature change –resistance and durability. Suitable to chemicals, anti-corrosive to usual chemicals. Application details 产品数据 Volume Solids 固体份 ≥98% Colour 颜色 Transparent or any color according to customer’s request, no gloss 物色，也可按照客户要求调配，无光 Dry Flm Thickness干膜厚度 100microns 100微米 Theoretical Coverage 理论涂布率 9.2m2 /Kg 9.2平方米/公斤 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 Allow appropiate A:B:C 20:0.2:0.15 by weight 甲：乙： 20:0.25:0.15（重量比） During mixing and Using ,be sure that it is free from foreign substances 混合和使用过程中应避免混入水等杂质 Induction Time 熟化时间 Not necessary 不需要熟化 Pot Life 使用期 15℃：60min; 25℃:30min; 35℃: 15min We can adjust the pot life and drying time according the temperature. 我公司可应客户要求根据涂装环境温度调整使期和涂膜干燥时间 After mix ,please use up it during the Valid time, or it is wasted. 涂料混合后，宜在使用期内用完，过期不能使用 Clear 油漆设备清洗 The tools shoulded be cleaned immediatedly with C015 afterapplication,or it is difficult to clean them 推荐采用C015，清洗工作应及时，涂料完全固化后，清洗工作将变得困难。 Drying time and Over coating Interval 干燥时间 覆涂时间 Substrate Temperature底材温度 Touch Dry 表干 （h） Hard Dry 硬干 （h） Completely Cure 完全固化 （d） Over coating Interval 推荐覆涂间隔 Mix最短 Max最长 15℃ 25℃ 35℃ 8 4 2 8 4 2 8 4 2 8 hours 4 hours 2 hours 26 hours 24