CCNA 2 - Module 11 Exam Answers.doc.docVIP

CCNA 2 - Module 11 Exam Answers 1.Refer to the exhibit. Router A is correctly configured for OSPF. Which OSPF configuration statement or set of statements was entered for router B to generate the exhibited routing table? * B(config-router)# network 192.168.1.0 0.0.0.3 area 0B(config-router)# network 10.16.1.0 0.0.0.224 area 0B(config-router)# network 10.16.1.0 255.255.255.224 area 0B(config-router)# network 192.168.1.0 255.255.255.255 area 0B(config-router)# network 10.0.0.0 255.255.255.255 area 0 2.  Refer to the exhibit. What does the “O*E2″ from the “O*E2 0.0.0.0/0 [110/1] via 192.168.1.1, 00:05:34, Serial0/0″ line represent? * an internal type 2 OSPF route.an external OSPF route at least two hops away.an external OSPF route from two different sources.an external OSPF route that will not increment in cost.a default route.The route was distributed into OSPF from a type 2 router. 3. What does OSPF use to reduce the number of exchanges of routing information in networks where large numbers of neighbors are present? (Choose two.) root routerbackup root routerdomain routerbackup domain router* designated router* backup designated router 4.  Refer to the exhibit. What is the cost of the route to the 10.0.0.0 network? 2110* 17861.544 5. What does OSPF use to calculate the cost to a destination network? * bandwidthbandwidth and hop countbandwidth and reliabilitybandwidth, load, and reliablity 6. What three parameters must be indentical between OSPF routers in order to form an adjacency? (Choose three.) * area idK-valuesmetric value* hello interval* network typeinterface type 7.  Refer to the exhibit. All routers have been configured with the interface priorities that are shown. All routers were restarted simultaneously. The results of the DR/BDR election are shown. What can be concluded about this network? Router C cannot win a DR election under any circumstances.If the link for interface 192.168.1.4 goes down, router B will bec