OC-MMFE-WDMSeries.doc.docVIP

10/100Mbps Ethernet Media Converter OC-MMFE-WDM Series User Guide Version No.:1.0 (Please Read Carefully before installation) Brief OC-MMFE series Auto-Negotiation Ethernet media converter provides connection and switch from 10/100Base-Tx to 100Base-Fx. It can extend network distance from 100m over copper to 2km over multimode fiber or to 100km over single mode fiber. Features ● Compliant with IEEE802.3/U 10Base-T 100Base-Tx/Fx standards ● Supports 802.3X full duplex and Back Pressure half duplex environments ● Linkloss alarm ● Auto MDIX ● Supports TS-1000 standards maintenance frame ● Power: 0.5A@5VDC ● Operation environment: Operation Temperature: 0-50℃ Storage Temperature: -20-70℃ Humidity: 5%-90%, non-condensing ● Dimension： 145x90x25mm ● Suitable for the chassis OC-C16M and OC-C1M-220. Ports RJ-45 PORT: UTP CAT.5, the maximum connected distance is 100m. FIBER PORT: SC/ST fiber port, suitable for 9/125, 10/125μm single mode fiber and 50/125, 62.5/125 μm multimode fiber. Panel Description Status Leds Generally, if link pass through alarm is OFF, Status Leds indicate the following: SYMBOL LEDS STATUS PWR Power Led On Indicates connection to external AC power. Fxlink Fiber Link TX Led ON：Link OFF：Disable Blink：Activity 100 Operation Speed Led ON：100Mbps OFF：10Mbps Txlink Copper Link TX Led ON：Link OFF：Disable Blink：Activity FDX Full / Half Duplex Led ON：Full Duplex OFF：Half Duplex SD Fiber RX Port Alarm Led ON：Fiber RX Port has signal OFF：Fiber RX Port loss of signal RMT-TXlink Remote equipment link led ON：Link OFF：Disable RMT-SPD Remote equipment link speed led ON：100Mbps OFF：10Mbps RMT-FDX Remote equipment Full duplex Led ON：Full Duplex OFF：Half Duplex Setting ON/OFF switches in the side of equipment, the default setting as following (The white part is the outshoot of ON/OFF switches) The functions as following： Number Function OFF ON Description 1 Link Pass Through Alarm Disables Enables Please refer to the following Link Pas