DL300_F_SYS_Dualine-system-startup_SS-R03-11.pdfVIP

® Farval Dualine Installation System Start-Up Bulletin DL300 BIJUR DELIMON INTERNATIONAL 2685 Airport Road • Kinston, NC 28504 Tel. 800-227-1063 • Fax: 252-527-9232 website: DC1-1 SECTION DC SYSTEM INSTALLATION AND START UP (For Dualine Automatic Electric Powered and Air Powered Systems) First study the schematic layout, the bearing list, and the applicable Farval publications describing dualine systems. Together they completely describe the system and its component assemblies. They also explain how the system and its component assemblies operate and how the various sub-assemblies-the pump, the reservoir, valve manifolds, and controls should be combined. In addition to becoming well acquainted with the lubricating system, it is often helpful to sketch the location of all manifolds and lube lines on the machine with chalk or crayon. INSTALLATION Pump Reservoir Assembly-Locate where it is protected from dirt and where it can be easily maintained and filled with lubricant. Bolt to a solid foundation (except air powered barrel pumps). Measuring Valves-Mount on a flat surface close to the bearings (within 10 feet) and close to the machine for protection but where accessible for adjusting and servicing. Valves may be mounted in any position but indicator stems should be visible and should face the same direction for easier checking. Mount with indicator stems down if excessive dirt and scale are present or order U-1732 indicator covers. Adjacent valve blocks may be piped together before mounting, using one union in each