变压器材料-混合物类检验.doc

Inspection standard for Compound 混合物类检验标准 1.0 OBJECTIVE 目的 To define a procedure that provides for acceptance of parts quality by the end user through inspection for a specification time at a specified distance. 建立此程序以确保通过最终客户定时定点的检测后所提供的零部件质量接收要求。 SCOPE 范围 DEFINE 定义 Major defects: Point serious impact to the vision and use; And can’t reach to the design requirement. 主要缺点: 指严重的影响使用及严重影响视觉;及无法达到原设计要求的缺点; Min defects: Point impact to vision; And no important dimension according to the ass’y drawing. 次要缺点: 指轻微影响视觉及非关键尺寸的缺点; SAMPLING PLAN AND ACCEPTABLE QUALITY LEVEL 抽样计划和允收水准 4.1 Sampling plan: 抽样计划 The sample plan according to item 7.0. 抽样计划参照项目7.0。 Acceptable Quality Level 允收水准: Defect for AQL 0 0缺陷， *REFERENCE INFO: MIL-STD-105E *参考资料: MIL-STD-105E 5.0 INSPECTION EQUIPMENT 检验设备 5.1 Appearance inspection : visual 外观检验：目视 6.0 INSPECTION CONDITION 检验条件 6.1 Distance: the distance is 30cm between eyes with material. 距离：肉眼与被测物距离30cm左右。 6.2 Inspection vision: Inspection must be made by individual with 1.0 vision or vision corrected to 1.0 检查视力：检验员裸视力和矫正视力为1.0。 7.0 INSPECTION CONTENT 检验内容 7.1 APPEARANCE INSPECTION 外观检验 S/N 序号 Inspection items 检验项目 Inspection standard 检验标准 Defect grade 缺陷等级 Sampling 抽样 MA MI 1 Type 型号 Accord with drawing or JDE须符合图纸或JDE要求 X 来料如果少于5桶，则每桶必须查看；如果超过5桶则至少得查看5桶以上 2 Useful-life 有效期限 Accord with drawing and setup useful-life in oneworld system 须符合图纸要求 ,并需要在oneworld系统中设置有效期 3 Manufacture name 生产厂家名字 Accord with drawing 须符合图纸要求 4 Out packing 外包装 Out packing 外包装 5 Viscosity report 粘性测试报告 Submit Viscosity report for supplier Wuxi Dongrun 无锡东润需提供粘性测试报告 7.2 FUNCTION INSPECTION 性能检验 7.2.1 Test name: curing and dipping testing1; 测试名称: 加工浸渍测试1; Part numbe