BIEE11G集群设置前置条件说明.docVIP

BIEE11G集群设置前置条件 1.两台或者多台机器的IP可以互相访问 2.主服务机(host1)安装好Weblogic后，在单独安装BIEE和配置。 3.辅助(host2)服务机安装好Weblogic后，配置Node Manager 6.1 Configuring Node Manager for CRMHOST2 Do the following: Run the following command: CRMHOST2 cd ORACLE_BASE/products/fusionapps/wlserver_10.3/common/nodemanager In the /nodemanager directory, copy the content of the node-specific directory to CRMHOST2. In this case, CRMHOST1 is the node-specific directory. 将主机里的NodeManager文件夹直接覆盖辅助机上的NodeManager文件夹 CRMHOST2 cp -r CRMHOST1 CRMHOST2 Change directory to CRMHOST2. You should see the following files: nm_perties nodemanager.log startNodeManagerWrapper.sh nodemanager.domains perties Note: Manually delete any lock files that may be present. For example, nodemanager.log.lck. 注意:删除所有锁定文件,如 nodemanager.log.lck In the nodemanager.domains file, edit all the domain paths that are local to CRMHOST2. For example, CRMDomain=/u02/local/oracle/domains/CRMHOST2/CRMDomain. 修改nodemanager.domains文件，将其中的Domain路径修改成辅助机的路径， 如:CRMDomain=/u02/local/oracle/domains/辅助机/CRMDomain.此处貌似不用修改，需留意！ Note: Because BIDomain is a bit different, an example path would be BIDomain=/u02/local/oracle/config/domains/CRMHOST1/BIDomain. 注意: BIDomain有点不同,比如:路径将会是 BIDomain=/u02/local/oracle/config/domains/CRMHOST1/BIDomain. In the startNodeManagerWrapper.sh file, change NM_HOME to ORACLE_BASE/products/fusionapps/wlserver_10.3/common/nodemanager/CRMHOST2. 注意: startNodeManagerWrapper.sh 未找到，只找打F:\Oracle\Middleware\wlserver_10.3\server\bin\startNodeManager.cmd和sh文件，NM_HOME无，但 是有能够对应上的NODEMGR_HOME,初步判读一个意思.此处修改未知是否必行，需测试后补充！！！ In the perties file: 以下是修改perties文件 Ensure that the path to the local machine /u02/local/oracle/nodemanager/ exists, and that the LogFile value is pointing to /u02/local/oracle/nodemanager/CRMHOST2.log. Ensure that the path for DomainsFile and NodeManagerHome are correct for CRMHOST2. 确认文件路径正确，确保domainsfile和nodemanagerhome路径是正确的.针对辅助机器 Add or modify the following lines: 添加或修改 KeyStores=CustomIdentityAndCustomTrust Cu