blease+focus+700麻醉机开机指南.docVIP

○ 太空实验室BLEASE FOCUS 700麻醉机开机指南 1、检查气源与电源是否正常连接，是否处于正常工作状态。 2、将传感器连接于回路Y形端口，并连接于回路封堵塞将回路封堵。 3、将回路旁路开关置于吸收罐位置，打开气源开关，打开呼吸机开关至成人或小儿，进入开机自检。 7xx Compliance and pre-use test Yes No 显示呼吸机软件信息 是否进行顺应性检测 您可以点“Yes”确定、点“No”取消 Compliance compensation is OFF Fresh gas compensation is active Leak test not carried out 若点“No”后，顺应性补偿关闭 新鲜气体补偿打开 泄漏补偿关闭 Set absorber to ‘vent 将回路开关置于机械通气位置 1) Occlude circuit at flow sensor 2) Disconnect gas sample line from patient flow sensor and occlude the sample port 3) Fill bellows 4) Ensure min. fresh gas 5) Check absorber is set to Vent and to on position 6) And then confirm 1) 连接传感器到回路并将开口堵塞 2) 确认流量传感器上的气体监护采样管已断开，接口已堵塞 3) 按下快速充氧开关将风箱充满 4) 调节新鲜气体流量到最小 5) 将手动/机械转换开关置于“机械通气”并将旁路开关置于“吸收器” 6) 按 CONFIRM 键继续 Compliance set Performing leak test Please wait … Passed leak test 顺应性设置 漏气自检 请等待 漏气自检已通过 Compliance set Set absorber to BAG 顺应性设置完成 将手动/机械转换开关置于“手动通气” System check? Yes No System check relies on the operator observing results 系统状态检查 您可以点“Yes”确定或点“No”取消 系统状态检查需人机互动完成 a) Ensure fresh gas is set to minimum and circuit occluded b) Close APL (fully clockwise) c) Press fresh to raise pressure to approximately 40cmH2O d) Check 0 pressure drop in 5 Sec. e) Squeeze bag to feel APL open at approx 65cmH2O.Ensure the insp. Circle valve moves when squeezed f) And then confirm Confirm a) 调节新鲜气体流量到最小，堵塞传感器患者端 b) 顺时针关闭APL阀 c) 按快速充氧按钮使压力升至约40cmH2O d) 5秒钟内压力应无下降 e) 挤压手动皮囊至压力约65cmH2O时APL阀开始释放压力，挤压手动皮囊时吸气活瓣应有开启运动 f) 按CONFIRM 确认 确认 a) Ensure fresh gas is set to minimum and circuit occluded b) Set APL valve fully open c) Set 10 LPM Fresh Gas then wait 10 sec. Ensure patient pressure 5 cm d) And then confirm Confirm a) 调节新鲜气体流量到最小，堵塞传感器患者端 b) 将APL阀逆时钟完全打开 c) 将新鲜气体流量调至10L/min, 10秒钟内压力应 5cm d) 按CONFIRM 确认 确认 a) Ensure fresh gas set to min. b) Connect 2L bag as test lung . c) After leaving this screen run ventilator at adult defaults. d) Note the readings of the Expi