c307-94中文版-抗化学侵蚀灰浆、薄浆及整块铺面石料抗拉强度的标准试验方法.docVIP

C 307 PAGE 170 Designation: C 307 - 94编号：C 307 - 94 PAGE 165 Standard Test Method forTensile Strength of Chemical-Resistant Mortar, Grouts, andMonolithic Surfacings This test method is under the jurisdiction of ASTM Committee C-3 on Chemical-Resistant Nonmetallic Materials and is the direct responsibility of Subcommittee C03.01 on Test Methods.本规范由ASTM委员会C- This test method is under the jurisdiction of ASTM Committee C-3 on Chemical-Resistant Nonmetallic Materials and is the direct responsibility of Subcommittee C03.01 on Test Methods.本规范由ASTM委员会C-3抗化学性非金属材料委员会管辖，并由C03.01标准试验方法分委会直接负责。Current edition approved July 15, 1994. Published September 1994. Originally published as C 307 - 53 T. Last previous edition C 307 - 93a.现行版本于1994年7月15日批准，并于1994年9月出版。最初版本编号为C307-53T，上一版本编号为C 307-93a。 This standard is issued under the fixed designation C 307; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval. 本标准以固定编号C307刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示必威体育精装版重新批准的年份。上标(ε)表示自上一修订版或重新批准后的编辑性修改。 This test method has been approved for use by agencies of the Department of Defense. Consult the DoD Index of Specifications and Standards for the specific year of issue which has been adopted by the Department of Defense.该标准已经批准被美国国防部机构使用。已被美国国防部采用的该标准出版的具体年份可以查看美国国防部技术和标准索引。 1. Scope 适用范围 This test method covers the determination of tensile strength of cured chemical-resistant materials in the form of molded briquets. These materials include mortars, brick and tile grouts, machinery grouts, and monolithic surfacings. These materials shall be based on resin, silicate, silica, or sulfur binders.本试验方法覆盖模塑试块形式的抗化学腐蚀的固化材料的抗拉强度的测定。这些材料包括灰浆、砖块、填缝剂、机械薄浆和整块铺面石料。这些材料应建立在树脂、硅酸盐、硅土或者硫磺粘合剂的基础上。 The values stated in inch-pound units are