RIP 动态路由协议的配置(实验报告).docVIP

学 生 实 训 报 告 实训课名称 ________ 计 算 机 网 络_______ 实训内容 RIP 动态路由协议的配置 学 院 数信学院 年级 050711 专 业 数学与应用数学 学 生 姓 名 ___ 杨义_ 学 号__ 13 _ 开 课 时 间 _ 2007__ 至 _ 2008_ 学年第_ 一_学期 RIP 动态路由协议的配置 实训环境与网络拓扑结构图 ①实训模拟器材：2台PC和3台2500路由器 ②拓扑结构图: 2. 实训内容 配置路由器R1、R2和R3的各个接口的IP地址，在每个路由器上配置RIP路由协议，然后测试R1到R3的连通性。 3.实训步骤 ①配置路由器各个接口的IP地址 路由器R1的配置: Press Enter to Start Router Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R1 R1(config)#interface E0 R1(config-if)#ip address 192.168.1.1 255.255.255.0 R1(config-if)#no shut %LINK-3-UPDOWN: Interface Ethernet0, changed state to up R1(config-if)#exit R1(config)#interface S0 R1(config-if)#ip address 192.168.2.1 255.255.255.0 R1(config-if)#clock rate 6400 R1(config-if)#no shut %LINK-3-UPDOWN: Interface Serial0, changed state to up %LINK-3-UPDOWN: Interface Serial0, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down R1(config-if)#exit R1(config)#exit R1#write memory Building configuration... [OK] R1#copy running-config startup-config Destination filename [startup-config]? Building configuration... [OK] 路由器R2的配置: Press Enter to Start Routeren Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R2 R2(config)#interface S1 R2(config-if)#ip address 192.168.2.2 255.255.255.0 R2(config-if)#clock rate 6400 R2(config-if)#no shut %LINK-3-UPDOWN: Interface Serial1, changed state to up R2(config-if)#exit R2(config)#interface S0 R2(config-if)#ip address 192.168.3.1 255.255.255.0 R2(config-if)#clock rate 6400 R2(config-if)#no shut %LINK-3-UPDOWN: Interface Serial0, changed state to up %LINK-3-UPDOWN: Interface Serial0, changed state to down %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down R2(config-if)#exit R2(config)#exit R2#write memory Building configuration... [OK] R2#copy running-config start