冻干机手动和自动操作指南.docxVIP

Freeze-drying Operation 操作用户操作设备进行冻干程序操作 Logging in control system is needed before operating the equipment. In the control system, freeze-drying process can be done through 2 methods. 操作用户若需要对设备进行操作需要先登入控制系统。在控制系统中对于冻干可通过2种方式来完成 Automatic Control自动控制 Manual Control手动控制 Operator runs automatic control to do freeze-drying operation 操作用户运行自动控制进行冻干流程操作 In automatic control, switch all the control components to automatic control status at first and then set the recipe parameters. After that, “START AUTO.” will appear. User clicks the “START AUTO.” button to start automatic program. 在自动控制中需要先切换把所有的控制部件切换到自动控制状态，然后设置配方参数，当设置好配方参数后“开始自动”按钮会显示，用户点击“开始自动”按钮启动自动程序。 Control components open and close automatically according to automatic program. At the meanwhile, status of “AUTO” on the right upper corner will become green and the interface switch button “FREEZE_DRYING” on the left lower corner will also has small green frame. 自动程序运行后控制部件按程序自动运行开启和关闭，同时在界面右上角的”自动状态会显示绿色、左下角的“冻干”界面切换按钮也会有绿的小方框显示。 The operation status of automatic program can be displayed by clicking the “Program” button on right lower part and switching to program operational status. 自动程序的运行状况可点击界面右下部分的“程序”按钮切换到程序运行状态显示。 Control Components Switch to Automatic Control Status 控制部件切换到自动控制状态 Click any control components on the interface and digital signature of components control will pop up. After entering the user name and password, component control picture will appear. Click “ALL THE COMPONENTS CHANGE TO AUTO MODE” button and all the components control turn to automatic model. Users can find out status switch from the status icon beside components picture on the interface. 点击界面的任何控制部件会弹出部件控制的电子签名，输入操作用户和密码后显示部件的控制画面，点击”全部切换为自动”按钮后所有的控制部件切换为自动模式，用户可从界面部件画面旁的状态图标可看出状态的切换。 Recipe Parameters Setting 设置配方参数 Before running the automatic programs, recipe parameters should be set and downloaded to the PLC in order to run the program according to designed process. If above operation will not be done, “START AUTO.”