年产7.5万吨丁苯橡胶装置聚合工段工艺设计 毕业论文.doc

STYLEREF 论文题目 \* MERGEFORMAT 错误！文档中没有指定样式的文字。 化工与材料工程学院毕业设计 年产7.5万吨丁苯橡胶装置聚合工段工艺设计 Annual production capacity of 75,000 tons polymerization styrene-butadiene rubber plant process design section 学生学号 学生姓名 专业班级 指导教师 联合指导教师 完成日期 吉林化工学院 Jilin Institute of Chemical Technology STYLEREF 模板名称 \* MERGEFORMAT 化工与材料工程学院毕业设计 - PAGE II - - PAGE II - STYLEREF 模板名称 \* MERGEFORMAT 化工与材料工程学院毕业设计 - PAGE 4 - 摘　　要 本设计为年产7.5万吨乳聚丁苯橡胶装置聚合工段工艺设计，在文献调研和现场调研的基础上，进行了丁苯橡胶生产方法及工艺的论证，确定了以丁二烯、苯乙烯为单体，采用氧化还原体系为引发剂，歧化松香酸甲皂为乳化剂，配合其他助剂进行低温乳液共聚合的生产工艺。在掌握各种物料的基本性质、聚合机理、聚合方法、工艺流程以及国内外的发展现状的基础上，进行聚合工段的物料衡算、热量衡算、设备选型计算，并对丁苯橡胶车间进行了技术经济分析。在此基础上绘制出丁苯橡胶工艺流程图、设备布置图、管道布置图，编制了设计说明书. 关键词：丁苯橡胶;乳液聚合;生产工艺 Abstract The design for the 65,000 tons annual production capacity ofpolystyrene-butadiene rubber emulsion polymerization plant process design section, in the literature research and field research on the basis of a styrene-butadiene rubber production methods and technology demonstration to determine a butadiene, styrene for the monomer, the redox initiator system, a disproportionation rosin acid soap as emulsifier, in conjunction with other additives for low-temperature emulsion copolymerization of the production process. In the grasp of the basic properties of various materials, polymerization mechanism, polymerization methods, the development process and the status quo at home and abroad based on the section of polymeric material balance, heat balance, calculation of equipment selection, and styrene-butadiene rubber plant techno-economic analysis carried out. On this basis SBR process to map out plans, equipment layout, piping layout, the preparation of the design specification and calculation of the book. Key Words：Emulsion; styrene-butadiene rubber ;production technology - PAGE 26 - - PAGE 40 - 目　　录 TOC \o 1-3 \h \z HYPERLINK \l _Toc232597489 摘　　要 PAGEREF _Toc232597489 \h I HYPERLINK \l _Toc232597490 Abstract PAGEREF _Toc232597490 \h II HYPERLINK \l _Toc232597491 第 1 章 第一篇绪 论 PAGERE