纺粘无纺布设备英文说明书spunbondelectricmanual.docVIP

PAGE PAGE 29 Spunbond nonwoven production line electrical control Instruction manual Wenzhou ouhai second light industrial machinery factory Contents 1、product introduction 2 2、system requirements 3 3、electric control system introduction 4 4、 touch screen introduction 7 5、 normal trouble shooting 11 6、 590 DC drive trouble table list 18 7、 FUJI inverter trouble protection action list 20 8、 RKC parameter specification table 22 9、Pre-filter pressure controller inner parameter table（PW206）- 25 10、Post-filter pressure controller inner parameter table (F900) 26 11、Post-filter pressure controller inner parameter(FB900) 27 12、 maintenance notes 28 13、 wearing parts list 29 Product introduction Our spunbond nonwoven line uses polymer directly melted ,push and extracted into small filaments, stretching in the flow field using the air dynamic theory, then decelerates in the way of air diffuse and stick together as a web on the spin belt. Our machines have three specification, 1.6 M,2.4M,3.2M.The entire machine consists of following parts: Main extruder, co-extruder, material auto-suction system, master batch and additive blending device, filter, spin pump, monomer fan, upper stretching unit, bottom stretching unit, spin belt carriage, calendar, winder, die heater, calendar heater, AC system, cooling air blower, suction blower, air-compressor, slitter, oven, etc. Processing steps as follow Additive(scrap recycled) 　 Material supplymelting and extrudingfilteringmeasuring volume and pushingspinningcoolingstretching deposition on the webembossing and formationslitting and packing The products mainly apply in packing, medical field, clothing interlining, etc. System requirements 1. Power voltage: three-phase five-wire, 3*380+N+PE 2. Power frequency: 50HZ 3. The maximum current system needs 1.6m width 2.4m width 3.2m width 4. Earthing : the earthing wire is half size of the any phase of power line.