基于PLC控制的带式输送机自动张紧装置设计（机械CAD图纸）.doc

优秀设计 摘 要 本设计主要是带式输送机全自动液压张紧装置的设计。它是在吸收国、内外输送机张紧技术的基础上，根据国内带式输送机的运行特点及要求研制的。它采用比例控制技术及可靠性较高的可编程控制技术，可以对张紧力进行多点控制，根据不同工作情况随时调节张紧力的大小。能最大程度的延长皮带的寿命，大大节约了成本。在设计中，用一个动滑轮使液压缸的行程减少了一半，避免使用行程较长的液压缸，减少了制造液压缸的难度。同时，系统中增加了若干个蓄能器，可以最大限度的吸收液压冲击，减小对皮带的冲击力提高胶带的使用寿命。 本设计在总结其它常规皮带张紧装置的基础上,设计了能够满足皮带机的皮带长度变化较大时的皮带拉紧装置。此装置在皮带机启动阶段,能提供足够大的启动张力；启动完毕后, 又可使皮带的张力恢复到额定值以维持皮带机的正常运行。本文根据液压自动张紧装置的液压原理,详细阐述了自动张紧装置的结构组成、控制原理及功能特点,并阐明了控制系统的设计关键在于压力值和最大拉力值的设定。 介绍了带式输送机运行系统要求,并运用PLC可编程控制技术对带式输送机的起动、制动和拉紧部分实时监控,完全实现了带式输送机自动控制运行方式,构成了一个高可靠性的设备运行控制系统。 关键词：带式输送机； 自动液压张紧装置； 自动控制； 可编程控制PLC ABSTRACT This design is mainly about full automatic hydraulic tension station for belt conveyer. It is designed on the foundation of opening technology in and outside, according to the domestic operation characteristic of belt conveyer and requirement. The equipment is also made on domestic belt-type conveyer movement characteristic and requestment. It uses the proportional control technology and the reliable higher programmable control technology, It may carry on the multi-spots control to strict the strength, adjusts pressing the strength size as necessary according to the different working condition.It can be the greatest degree lengthen the leather belt the life, greatly saved the cost. In the design, It causes the hydraulic cylinder with a movable pulley the stroke to reduce one half, and avoides using a stroke longer hydraulic cylinder.In this way,it reduces difficulty of the hydraulic cylinder’s produce. At the same time, it increases certain accumulators in the system, and limits absorption hydraulic pressure impact,which reduces the leather belt impulse and enhances the adhesive tape’s life. In this issue ,the belt conveyer device whose tension force varied greatly is desiged to satisfy the re2 quirement s of the st ressed belt in varied length. It s tersion is greater in starting state ,and smaller in normal state moving. In the basis of working principle of automatic hydraulic tensioning device , st ructure