Windows_Embedded_Standard_7_(WES7)定制手册汇.doc

Windows Embedded Standard 2011 CTP2 Lab Manual  Table of Contents 1 Preparing to Use Windows Embedded Standard 2011 5 1.1 Introduction 5 1.2 Related Windows 7 Documentation 5 1.3 Minimum Device Hardware Requirements 5 1.4 Release Notes 5 1.5 Install Windows Embedded Standard 2011 Toolkit 6 1.5.1 Open Windows Embedded Standard 2011 Toolkit Help 6 1.6 Create a Utility Drive 7 1.6.1 Make Your Utility Disk Bootable 7 1.6.2 Add Image Builder Wizard to Your Utility Disk 7 1.7 Create a Windows Preinstallation Environment Utility Drive (Optional) 8 1.7.1 Create a Windows PE Utility Disk with Image Configuration Editor 8 1.7.2 Create a Custom Windows PE Image 8 2 Build Windows Embedded Standard 2011 Images 9 2.1 Build a Windows Embedded Standard 2011 Image with Image Builder Wizard 9 2.1.1 Build a Thin Client Image with Embedded Enabling Features 9 2.1.2 Build an Image with Embedded Core Only 11 2.2 Build a Windows Embedded Standard 2011 Image Using Image Configuration Editor 11 2.2.1 Build a Thin Client Image with Custom Settings 11 2.2.2 Add Update Packages to a Distribution Share (Optional) 14 2.2.3 Add Third-Party Software (Optional) 15 2.2.4 Run a Custom Script (Optional) 16 2.2.5 Add Third-Party Drivers (Optional) 17 2.2.6 Make Your Install Fully Unattended (Optional) 17 2.2.7 Create Image Builder Wizard Disk from Answer File (optional) 24 3 Deploy an Image 25 3.1 Prepare and Capture an Image for Deployment 25 3.1.1 Sysprep the Image 25 3.1.2 Capture the Image Into a Windows Image (.wim) File 25 3.2 Deploy an Image Using ImageX 26 3.2.1 Prepare your Destination Device 26 3.2.2 Apply an Image to Your Device’s Hard Drive 27 3.2.3 Shut Down the Destination Device 27 3.3 Deploy an Image Using Image Builder Wizard 27 3.3.1 Start Image Builder Wizard with your Image 28 3.3.2 Customize a Captured Image 29 4 Service an Image 31 4.1 Service an Image with Image Configuration Editor and DISM 31 4.1.1 Create a Configuration Set using Image Configuration Editor 31 4.1.2 Install