外文翻译----设计加工螺杆式压缩机的内摆线-机械设计.docx

附 录 1 The Original English THE KEY TECHNOLOGY OF DESIGN HOB FOR HOBBING SCREW COMPRESSOR ROTORS WITH CUCLOID-ARC PROFILE ABSTRCT The profile of cycloid-arc screw compressor rotors is not a smooth profile; it has a tip on it. When design the hob cutter used for machining this kind of rotors, the profile of hob edge will appear separation. In this paper, the author made researches on the design theory of hob cutter for hobbing the cycloid-arc rotor with tip profile, and got the best way for design this kind of hob cutter with a separate edge. It is good practice to design the hob cutter and hob the cycloid-arc rotor according to practical design, manufacture and test. (1) INTRODUCTION The efficiency and reliability of screw compressor mainly depend on manufacturing technology of screw rotors. At present, the machining method of our country for machining screw rotors is milling the shortcoming of milling is low productivity and machining accuracy. Hobbing characteristic is high productivity and machining accuracy, so the machining method for hobbing instead of milling screw compressor rotors is now becoming more and more popular. Hobbing instead of milling for machining screw compressor rotors has much more advantage, but the key problem for carrying out hobbing the screw compressor rotors is that the profile of screw compressor rotors must be suited to hobbing. Our national standard profile for screw compressor rotors have no-symmetric cycloid-arc profile and symmetric are profile [1], since no-symmetric cycloid-arc profile screw compressor has much more advantage than symmetric are profile screw compressor, our national factory all adopt the former at present. The property of no-symmetric cycloid-arc profile is that the conjoint curve of profile isn’t slick curve, it has a tip on the profile, it is still a great difficult for hobbing instead of milling this kind of screw rotors in our country as the design problem of hob cutter. In this paper, we’ll make researc