基于ProE的启盖器运动仿真研究.docVIP

基于Pro/E的启盖器运动仿真研究----启盖器零件设计 完成日期： 指导教师签字： 答辩小组成员签字： 摘 要 随着生活水平的不断提高，追求方便快捷的生活已经成为主流趋势。启盖器作为一种方便的生活用具正逐步得到人们的青睐。本文针对启盖器通过Pro/E软件实现其动态仿真以及优化设计，同时对Pro/E软件的功能应用进行介绍。 本文通过分析启盖器的内轴、手柄的运动特点以及各零件的结构特征，通过Pro/E软件进行零件的绘制、装配、动态仿真。针对零件的绘制，通过拉伸、旋转、扫描、倒角、螺旋扫描、镜像、阵列等特征实现绘制。通过匹配、对齐、插入、缺省、固定等放置约束,以及销钉、滑动杆、圆柱等连接类型进行零件的装配。通过在手柄、内轴上加伺服电机使其运动，并设置个电机的运动起始终止时间来实现需要的运动。 在装配实现的基础上，对个各零件进行倒角，是零件符合加工条件。 关键词：启盖器，零件，装配，动态仿真， Abstract With the continuous improvement of living standards, the pursuit of fast and convenient life has become a mainstream trend.Cap opener as a convenient life appliances are gradually people of all ages.In this paper Cap opener by Pro / E software dynamic simulation and optimization of its design, while Pro / E software applications introduced features. This paper analyzes the inner shaft Cap opener, handle the motion characteristics and structural features of the various parts, by Pro / E rendering software components, assembly, dynamic simulation.For parts of the drawing, by stretching, rotating, scanning, bevel, helical scan, mirror, array and other features of Drawing.By matching, alignment, insertion, default, fixed place such constraints, and the pin, sliding bar, cylindrical parts such as the connection type for the assembly.Through the handle, plus the axis servo motor to movement, and set a motor movement to achieve the required initial termination time of the movement. Based on the implementation in the assembly, on a different part for chamfering, is the par