spc-512使用手册(英文).docVIP

SPC-512 Address Writer Tester Manual REV 1.0 2008.6.26 SHANGHAI SEMPING ELECTRONICS CO. , LTD. P.C: 200042 Tel: (86)21-5228 8520 Fax: (86)21-5228 8521 Web： Technical support ：support@ Add: Room 1706, NO. 868, Changping Road, Jing’an District, Shanghai Chapter 1 brief introduction of SPC-512 1.1 Summary SPC-512 is an Address Writer Tester, specifically designed for LED control system. It sets start address of DMX equipment in singles or in batches, replacing traditional setup modes which are depended on dial switch. Adopting our company’s LED control system composed by DMX Decoder Modules, will avoid troubles from dialing and setting address code for each light. At project site, workers set and dial too much address code, which easily leads to a series of drawbacks, namely dialing fallibility, dialing omission and excessiveness, etc. It also causes trouble to project commissioning. The design scheme for address setting of our company can cope with the troubles above. You just need to install LED fixtures, then, conduct the related operation by DMX Address Writer Tester to fulfill start address setting for DMX devices of entire system within several seconds. The full course is rapid, reliable, accurate and convenient. 1.2 Features: 1. Compact appearance, light weight, user-friendly operation interface, easy to test at project site. 2. Built-in battery, ultra-low power consumption, more than 100 hours of continuous work. 3. Set start address of DMX equipment in singles or in batches 4. Capable of sending single-channel and multi-channel of DMX signal, support the mode of spot test and effect of fading in/out. 5. Capable of receiving DMX signal, start address, refresh rate and channel value display. 1.3 Technical Specifications: Model: SPC-512 Input Voltage：DC 9-12 V Rated power: max 1 W Digital signal input/output: DMX512 Digital signal connector: XLR 5PIN*2 RJ45*1 Size: 100(W)*50(H)*125(L) mm Weight: 500g 1.4 Production diagram 1 LCD screen 6 Circular key