智能数控套料编程系统.doc.docVIP

InteGNPS InteGNPS Primer Guide All Rights Reserved InteGNPS InteGNPS Installation InteGNPS Installation guide: Install AutoCAD first, if AutoCAD already installed please skip this step. InteGNP support AutoCAD R12/13/14/2000/2002/2004/2005/2006/2007/2008 etc., recommend install AutoCAD 2000 later version. Insert InteGNPS softdog to your computer USB port, run integnps-setup.exe in CD, according to prompt click next step by step, insert or remove USB softdog needn’t power off computer, softdog drivers installed after setup finished, InteGNPS support Windows 98/2000/NT/Me/XP/Vista. After setup finished, needn’t reboot computer, direct click shortcut on desktop can enter InteGNPS. Click Draw menu item on in main menu，then pull down Load/Remove NC menu of AutoCAD, then popup a window as following: Click Load button ,then according to prompt and load NC menu to AutoCAD menu, InteGNPS will prompt to automatic compile NC menu in AutoCAD environment, after compiling, then you can see NC menu in AutoCAD menu , ONLY AutoCAD 2000 later version support automatic compile menu , otherwise you need compile it by keyed MENU in AutoCAD command line , when manual compiling it , please select ACAD.MNU file. After load NC menu, you can see NC menus as following: 2. Draw part When using AutoCAD to draw part, please care of following tips: Draw part with scale 1:1, the unit normal is mm, for proper unit for your InteGNPS drawings please refer to About in InteGNPS also. In AutoCAD DXF or DWG file , the layers of entities　consist with cutting technology, inner contour, outer contour, cutting bridge, marking, punching, drilling, riveting etc., all should be in their corresponding layers, you can use AutoCAD NC menu to change the layers, or change it by use AutoCAD command, cutting contour can has bridge or marking entities, drilling and riveting draw a circle, circle center is drilling or riveting center, InteGNPS support mixed cutting technology programming, in a program code can co