Windows2008下配置cisco radius server.docVIP

Windows2008下配置cisco radius server 配置环境： Windows2008 域环境 域管理员帐户登陆 基本步骤： ??Install the Network Policy and Access Service Role ??Register in Active Directory ??Configure the RADIUS Client Settings ??Configure the Access policy ??Configure the Cisco Device Install the Network Policy and Access Service Role ??From the Initial Configuration Task Windows -Click Add a Role ??Select the “Network Policy and Access Server Role” ??Select the Role Service “Network Policy Server” – This is all that is require to provide RADIUS authentication for our Cisco devices Register in Active Directory ??Once the Role has been configured then we can continue with the NPS configuration. You can find the NPS console under administrative tools ??Right Click NPS (local) and Select Register in Active Directory Configure the RADIUS Client Settings ??In the RADIUS Client and Server Folder Right Click RADIUS Client and Select New RADIUS Client ??Enter Friendly Name and IP address of the Cisco Device ??Select Cisco as the RADIUS Vendor ??Click Generate to make a unique RADIUS key (make sure you copy this somewhere you can access it later to paste into the Cisco Device) Configure the Access policy ??Right Click the Network policy and Select New ??Enter a Policy Name (Leave as unspecified) ??Enter a Windows Group Condition – Enter the name of the group from AD who should have access ??Enter a Client Friendly Name as a Condition – Enter the name of the RADIUS Client (we can use wild cards here so “CISCO–R?” would match multiple RADUIS Clients ??Enter a NAS-Port-Type as a condition –Select Virtual (VPN) ??Specify Access Granted in Specify Access Permissions ??Configure Authentication Method as PAP ??You can select No when asked if you want to look up the help file. ??There are no setting necessary in the “Configure Constraint” “Configure Settings” – Here is where we setup the access level ??Remove Frame-Protocol PPP ??Remove Service-Type Framed ??Select Vendor Specific ??Now Add Cisco Vendor Attri