1000TEU主机推进装置系统试验程序.docVIP

主机推进装置码头系泊试验程序 Main engine and propulsion device mooring test procedure 本程序适用于1000TEU集装箱船 按制造厂的推荐进行动车前的准备，试验工作必须在宜昌柴油机厂服务工程师的指导下进行。 Prepare for starting, Test working is gone on under the direction of engineer in Yichang diesel factory. 1、主要参数。 General technical data. 型 号Type 6S50MC-C 最大持续功率Continuous rating, max 9480KW 额定转速Engine speed 127rpm 旋转方向Direction of rotation 可逆转reversible 2、主机试验条件。 Condition of M/E test. 2.1 主机试验前对各相关系统必须进行完整性和安装质量检查和认可，主要有：主机起动空气系统；燃油日用系统；滑油日用系统；冷却海水系统；冷却淡水系统均经过安装和压力试验，并报验合格。 Check completely and quantity of systems before M/E test, then recognize: There are M/E starting air system; fuel daily system; L.O. daily system; cooling sea water system; cooling fresh water system. All systems are inspected after fixed and pressure test. 2.2 滑油日用系统注油清洗完毕。 L.O. daily system is filled oil to clean. 2.3 高温淡水冷却系统已注入软化添加剂的冷却水，膨胀水箱达到规定的水位高度。 H.T.fresh cooling system is filled cooling water of soften additive expansion chamber arrives at water level of being specified. 2.4 主机轴系安装报验合格。 Fit and inspect shaft line of M/E. 2.5 服务于主机的各种设备进行了运行试验，运行正常、合格。 Operation test of all major equipment working for M.E., Run normally、eligibly. ⑴、泵类：主机滑油泵及备用泵，主机高温冷却备用泵，两台主机低温淡水泵，两台主海水泵，主机缸套水预热泵，供油单元中的两台燃油供给泵和两台燃油增压泵均应进行效用试验，试验时间15分钟。检查其启动、停止、开关动作的正确性和可靠性，试验时各运动部件应无敲击、异常发热、泄漏等现象，并测量记录泵排出压力，电动机的电压、电流及绝缘电阻值（见表一）。 Pumps: 10 minutes test of M.E L.O and stand by pump, H.T Fresh water pump, two M.E L.T Fresh water pump, two main S.W. pump, two Fuel oil feeder pumps and two fuel oil booster pumps in fuel oil feeder booster. Check the exactly and reliability of starting、stopping、 action of switch .No knock 、abnormal heating or leakage of all pumps admitted, during operation . Measure and record output pressure of pumps、voltage current and insulation resistance value. ⑵、盘车机构的电机和电器箱冷态绝缘测量，并试运行15分钟，记录电机的转速、工作电流及电压。（见表一） Measure insulation of motor of and electric box ,try to run 15 minutes, record rotation、c