涂料与涂装保护规范.doc

PAINT AND PROTECTIVECOATING SPECIFICATION 涂料与涂装保护规范 1204-SP-0001 REVISION B ALL FMC SOFEC MOORING SYSTEM PROJECTS 用于所有FMC SOFEC 锚泊系统项目 PAINT AND PROTECTIVE COATING SPECIFICATION 涂料与涂装保护规范 REVISION HISTORY 修改历史 REVISION A 版本 A Original Issue of Specification under this number. This specification, which was previously issued as Specification SP-PC-01, Revision 0, is being revised to reflect the new Product Code Structure numbering system. REVISION B 版本 B Revised per ECN 60302 (a) Added with FMC SOFECs approval and Product to Sectoin 3.3 (b) Added to define the applicable Paint / Coating System and top coat color to Section 3.4.1 (c) Added corner / edge of bolt holes to Section 4.1 (d) Deleted Bolt holes shall be smoothed and and added and corners to Section 4.2 (e) Added bearings and mechanical equipment / components to Section 4.3 (f) Added Section 4.10.1 (g) Deleted A minimum of 6 inches (150 mm) around edges of abrasive blasted areas will be left unprimed unless adjoining a painted surface. And added When an area of abrasive blasting adjoins a painted surface, in Section 4.13 (h) Added Section 6.1.3 and renumbered existing Sections 6.1.3, 6.1.4, 6.1.5 and 6.1.6 (i) Deleted of the first two (2) from Section 6.1.6 (j) Added Machined contact surfaces shall be coated per the written instructions of the FMC SOFEC Representative. To Section 6.4.1 (k) Revised Section 9.5.1 (l) Revised Tables 2.0-1, 2.0-2, 2.0-3 and 2.0-4 · Multiple revisions to the Area/Equipment, System, Top Coat Color and Notes sections of each Table PAINT AND PROTECTIVE COATING SPECIFICATION 涂料与涂装保护规范 TABLE OF CONTENTS 目 录 1． SCOPE 适用范围 2． REFERENCE STANDARDS 参考标准 3． GENERAL 概述 4． SURFACE PREPARATION 表面处理 5． STORAGE, MIXING AND THINNING存储、搅拌和稀释 6． GENERAL PAINTING PROCEDURE 一般涂装程序 7． THERMAL SPRAYED ALUMINUM 热喷铝 8． GALVANIZING 镀锌 9． INSPECTION 检验 TABLE 1.0 PAINT / PROTECTIVE COATING SYSTEMS表1.0涂料与涂装方法 TABLE 2.0 - 1 APPLICATION SCHEDULE - CALM BUOY浮筒平台 TABLE 2.0 - 2 APPLICATION SCHED