汽车打蜡步骤（Waxing steps）.docVIP

汽车打蜡步骤（Waxing steps） Waxing steps in cars? The first step: car wash, where the gap in the car wash dirt, in the final clearance before the steps to ensure that the body dry, there is no residual moisture. ?? The second step: to tar, insect carcasses, resin and so on? (1) first cleaning the body, you can see the asphalt particles. But for dark cars, it is difficult to find, and there is no such feeling. (2) apply diesel or kerosene to clean towels, and apply lightly to asphalt. Or spray diesel or kerosene in the spray container and spray it on the asphalt. (3) wait for the tar to dissolve on the body. ?? (4) after cleaning the dissolved asphalt, if it is still not completely dissolved, add some diesel or kerosene to dissolve it. ?? (5) clean it immediately, clean it with clean water and wipe it clean. Main point: dont leave the tar cleaner on the paint surface for too long. Quality standards: all cars, no tar, insect carcasses, resin marks? The third step: smearing the car wax? (1) apply a proper amount of wax to the wax sponge, and evenly coat the wax in a small circle; the size of the circle shall be within the circle without missing paint, The front circle of each lap is 1/3, and the circle path follows the front and rear direction of the car body. ?? (2) the order of waxing of the whole car: divide the paintwork into several parts, press the front left cover, front left cover, right front wing, right front door, right rear door- The right rear wing - the trunk covers the right half of the body and the left half of the body in reverse order. Until all the paintwork has been waxed without omission. (3) evenly spread a thin layer of car wax on all the paintwork. The coat shall be covered with a layer of car wax, and the plastic bumper should be painted before and after the painting. Main point: the best thing to do in shady places is that the car body is not very hot; circle the body with a wax sponge and apply wax evenly over the surface of the car On the top, requ