模具厂制作标准化设计 流程 作业指导 模具组立 9s)（Standard design flow of die factory, operation instruction, mould assembly, 9S)）.docVIP

模具厂制作标准化设计 流程 作业指导 模具组立 9s)（Standard design flow of die factory, operation instruction, mould assembly, 9S)） The teacher, so preaching by the industry doubts. God cherishes the grass, respect seniors. Wear butterfly butterfly deep see, water dragonflies fly slowly. Where there is a will, there is a way. Your no acquaintance, long song Huai wei. Die master, vomiting blood, dedicate their essence, and help you become a master! Die factory standardization, design + process + operation guidance + die group set +9S One: Design 1., for different customer requirements, the requirements of mold design 2. different mold numbers and marking for different customers 3., for different households, the factory made use of steel and distinction 4., for the factory to do a relatively successful mold, the design of new participation in communication guidance 5., the mold of the mold and accessories, such as the surface of the logo, standardized unity 6. responsibility and efficiency of the mold to be designed 7. analyze the design, structure, layout, inspection, strength, action, possible defects and deficiencies of the mold, and feedback 8., the design of the mold forming parts of the product analysis: trapped gas, top out, filling, shrinkage, positive and negative, easy to break, easy to rough edges, product lines, side wall scratch, deformation, clip mouth, assembly size, etc. 1: analysis of trapped gas products to fill the bone, depth, flesh, product corner filling difficulty, combined with the location and flow of the shapes and forms of the exhaust 2顶出:产品容易顶白的位置,骨位的深度及拔模角度,胶柱孔的顶出，司筒针的强度,扁销的强度尽量在1.0*5.0以上,扁销的顶出位置产品的侧壁和骨位位置,尽量在产品没饱和的状态下,产品亦不会残留在模内,扁销的顶出强度托长或者扁销加宽单侧做骨位或胶位,顶面顶产品底面和底面,斜顶的度数强度及想接的斜顶座,顶杆,导向块的做法对比,推板的强度,直顶,直顶斜块,斜块的回位及受力强度,前模的斜顶和斜弹,滑块的脱模动作与回位,产品上斜孔的开模动作和回位机构,型腔内是否考虑两次开模,脱开易顶出受力可能顶白的位置指开模时,型芯某部位先退,产品是否会 When the ejector head is out of balance, the top of the ejector head is slipping 3 fill the same product mould in qualifying, analysis of average pressure of filling the