机柜制作流程（Cabinet making process）.docVIP

机柜制作流程（Cabinet making process） First, the preparatory work: 1, the cabinet (see how much U) to observe the space; 2, the cabinet diagram (this is the most important part of the cabinet, all in accordance with the steps of the whole map to do, reasonable arrangement floor); 3, room corresponding table, corresponding room tag; 4, the scheme should be discussed together, made for merit (timber, aesthetic, work time, quality, etc.); 5, slow; attitude; responsibility; teamwork; The use of tools (wiring rack, tray, two layer, three layer switch [], wire ring, panel cabinet, use [] [color] white, module and panel [room], screwdriver [flat], plum, small electric drill, line device, walkie talkie, [small pliers pliers, pliers, pliers, wire, wire stripper], wide tape, label [into the cabinet front label, label, the label on the exchange floor, each room, a large number of screw cap / label], [], tied with different crystal head [super 5, 6], crystal head [color], and gray, scissors, pens, five lines, six lines) Two, detailed steps: 1, room playing module (each room for two lines, unified beat White module); pay attention to: line order 2 、 distribution station line (clean line will clean up the dirt on the line); 3, measuring line (using line measuring instrument to detect 1/2 line and mark on the 1 line, at this time, the distribution station will also distinguish 1/2 line, immediately affixed room labels, every six rooms tied into a bundle and marked on the bundle); 4, room upper panel (after the completion of 1/2 line panel); 5. Match (bind the cabinet into the cabinet, twelve on each rack, six rooms for each side; 6, shelves, threading, left line module (corresponding to the floor, do, the corresponding room number, cabinet, cabinet level) online and room number on the wiring frame corresponding to the label, bending the frame after stay more than one meter line, so suitable, before leaving the frame module about 15cm, and then use the according to the painting line marki