专业音响 - c-mark 教你怎样使用数字音频处理器（Professional audio - c-mark teaches you how to use a digital audio processor）.docVIP

专业音响 - c-mark 教你怎样使用数字音频处理器（Professional audio - c-mark teaches you how to use a digital audio processor） Professional audio - C-MARK teach you how to use the digital audio processor.Txt In the digital audio processor is more and more used in the project, for the basis of experienced people, the processor is a very good tool, but for some of the experiences of lack of friends, looking at a processor, and a lot of English, it was impossible to start. In fact, dont panic, let me introduce the steps of using the processor. R% J, S3 X2 S; With a 2 and 4 processor control full frequency loudspeaker system + subwoofer for example: 1, the first is connected with the processor system, first determine which output channel is used to control the full frequency loudspeaker, which is used to control the subwoofer output channels, such as you use output 1, 2 channel control super bass, with 3 output, 4 channel full frequency control. Connect the wire, enters first processor (EDIT) interface to edit settings, enter edit method of product interface different, how to enter, to read the instructions. 2, using the route processor (ROUNT) function to determine signal output channels from which input channels, such as you use stereo sound form, you can choose the output signal from the channel 1, 3, 4 of the 2 A input signal from the input B output channels. Different signal distribution function of different products position, some are in the frequency module, some are in the gain control module, according to the instructions to this specification. 3, according to the technical characteristics of the speaker or the actual requirements of speaker of the band set, which is set the crossover point. The frequency module on the processor is usually expressed by CROSSOVER or X-OVER, after entering the lower limit frequency selection (HPF) and the upper limit frequency selection (LPF), but also the filter mode and slope selection. First of all, to determine the frequency, such as ultra bass