一锅双星（Binary Galaxy）.docVIP

一锅双星（Binary Galaxy） A binary 3S and 6B Equipment: a diameter of one point five meters or more antennas. The first two C, two feed plate. A 6 cm, a 13 cm, a four cut (Diseqc) switch (for receiving more satellite). A receiver. Installation: to Asia 3S105.5 satellite. The LNB1 interface is connected with the switching switch LNB feeder, the receiver set Dseqc to port 1. High on the middle of the star 6B for receiving satellite and 115.5 degrees. The tuner on the main tuner on the left (facing the cauldron). The LNB2 interface is connected with the switching switch feeder tuner. The Diseqc receiver is set to port 2. After adjustment of satellite link. The first adjustment: adjustment of the main satellite. Diseqc receiver switch for port 1. First select the settings - New transponder transponders. The program parameters enter a 3S Star TV in asia. When only more than 70 per cent of the signal strength, signal quality is zero or very small, indicating the connection is correct. Only the azimuth and elevation is not adjusted. A rotation angle below, and see whether there are changes in the signal quality, as long as there is a small change that captures the satellite signal, and then carefully adjust the azimuth angle and elevation, the signal quality reaches the maximum value. After adjustment, press the OK button on the OK. This alignment of the satellite. Other programs can automatically search the input. One can also search for everything. And then adjust the tuner. Diseqc receiver switch for port 2. Choose settings - New transponder transponders. The program parameters enter a star of the 6B satellite. I input the parameters of Fujian southeast of Taiwan. At that time the only signal intensity is more than 70 per cent, the signal quality is zero or very small, the first tuner is not fixed. Hand in the different position for Pan tuner signal. At the same time to see changes in the signal quality. When the signal quality changes that capture the satellite signal. Write