gpsrtk入门篇(rtk)（Gpsrtk入门篇 (RTK)）.docVIP

gpsrtk入门篇(rtk)（Gpsrtk入门篇 (RTK)） The second chapter introduction article The introductory chapter is the main content to help new users as soon as possible to understand the Topcon GPS RTK outside the industry within the industry and operation process, in order to be able to use GPS RTK TOPCON production. There are two main operations: RTK RTK measurement, RTK measurement. This article will introduce RTK and RTK measurement lofting operation and in process industry. Flow chart of 2 - 1 RTK operation RTK includes two parts of base station and mobile station operation operation. RTK, a base station operation process: Two, RTK measurement of flow operation station: Three, RTK mobile station lofting process: Section 2 - 2 RTK survey observation preparatory work before Suppose there are two Taiwan TOPCON GPS RTK device, a base station and a mobile station, WGS84 coordinates of the base station by using single point positioning, BJ54 coordinates of the base station using the assumed value, the requirements for mobile station RTK measurement and lofting. Section 2 - 3 RTK base station wiring diagram The connection method of RTK base station: The GPS radio receiver antenna GPS antenna Ant A Pwr C The wiring diagram of section 2 - 4 RTK mobile station The connection method of RTK mobile stations: Radio antenna GPS antenna GPS receiver Ant A Pwr C radio Section 2 - 5 RTK base station operation In 1, the base station to settle in leveling the Topcon GPS receiver, antenna and radio transmitting station, connecting the battery, the GPS antenna; 2, GPS boot, Ranger boot hand book, running hand book on the Survey Pro software, display: [Create a New Job] [Next] [Next] [Finish] [Settings] settings are as follows: [Receiver settings] Topcon TPS All Models [Change] [Auto Detect] (not on the connection can be detected automatically) [Receiver Set], return to the [General], enter the height angle (10 degrees) Return to [OK] [OK] Survey Pro, return to the main menu [Survey] [GPS Status]