cad转pkpm（CAD turn PKPM）.docVIP

cad转pkpm（CAD turn PKPM） PKPM_AXIS In fact, because the first installed PKPM and CAD installed in the pkpm\cfg directory, as long as the inside of several *.mnu and *.mnc files are copied to the X:\Program Files\AutoCAD R14\SUPPORT, and then start the CAD no problem. 1, the following files (can be found under the PKPM/CFG DWGTOPM.mnc dwgtopm.mnr dwgtopm.mns): DWGTOPM.cui DWGTOPM.mnu TchDwg2004.arx TchForDll.dll to copy all the files to the Autocad2004 2006 or above the root directory; 2, run Autocad2004 or 2006, TchDwg2004.arx is selected in the tools / load application, double-click can be loaded; 3, in the Acad directory to build a text document, write the contents of the C:\PKPM\CFG\TCHDWG2004.ARX is saved as ACAD.RX files After the open Acad can be automatically loaded. If you are in the PKPM line a line modeling, that obviously you have left behind, personally think that the fastest way is imported from CAD by using the PKPM model, with winXP, pkpm2005, 2004, CAD2004 (it used software) as an example, the detailed description is as follows: 1), in the CAD toolbar to load the application loading of pkpm\cfg\tchdwg.arx (2000), after loading there should be a PKPM toolbar toolbar in third is converted to DWG files PKPM model file, the third will appear in a dialog box, point axis, the corresponding wall layer, column layer etc. at this time, can, can be the standard layer one by one into the conversion. 2) after conversion into the PKPM began to open the PKPM working directory in CAD, press the Tab key to find the file name, did not change the word is aa.jwn. 3) after entering can see the corresponding model, you may find that at this time, the standard layer is not in the same position, so you should be adjusted, the method is as follows: to find a reference point, such as absolute coordinates (0,0), first run the L command in a painting line, standard layer input 0,0! That is, to find the origin of coordinates, and then in the model to find a representative model